AskoziaPBX – Preconfigured Image – Getting Started

Prerequisites
 
The information in this document is based on these software and hardware versions:
 
·         Alix23x Embedded Appliance with preconfigured image installed
·         A PC with Ethernet connection
 
Getting started
 
After installed the preconfigured AskoziaPBX image on Compact flash (see Write Askozia image on CF), you are able to connect to the ALIX embedded appliance for verify configuration and tune it!
 
The embedded Appliance start with 192.168.1.1 preconfigured LAN IP ADDRESS interface and with Username admin Password admin
 
Attach an Ethernet cable from Ethernet interface of your PC and the LAN interface of the embedded device; put your PC ethernet interface in the same network address space of the embedded appliance for connect to it (for example 192.168.1.10 and netmask 255.255.255.0).
 
alix3front02
Try to reach the embedded device with an ICMP request from command line interface of your PC:
 
ping 192.168.1.1
 
you should receive an ICMP response; this indicate that you can connect via http and view/modify the configuration.
 
http://192.168.1.1

You will be asked to insert username and password for login!

Tags: , , , , , , , , ,

Tuesday, August 4th, 2009 AskoziaPBX

No comments yet.

Leave a comment

 

Categories

AskoziaPBX

Create your full features PBX IP with voicemail and Automated Attendant with alix2d3 or alix2d2 system board.

You can find the PBX IP preconfigured image here:


And obtain all support information "how to" here: